Filter
Top Products
22
REMOTE OPERATION
While you are away from your home or
office, you can use a touch-tone phone
or a pulse (rotary) phone with a pocket
tone dialer to enter your remote opera-
tion security code and do any of the fol-
lowing:
• set the TAD-724 to answer calls
• listen to your messages
• record a new announcement
• record a memo
• delete individual or all messages
• change the security code
• turn on the room monitor
CHANGING THE
REMOTE OPERATION
SECURITY CODE
To use your TAD-724 from a remote
telephone, you must first enter a 3-digit
remote operation security code. The
security code for your TAD is preset to
500. You can use the preset code, or
follow these steps to change it.
Notes
:
• In Steps 2 and 3, you must enter
your selection within 10 seconds.
Otherwise, the TAD beeps once
and exits the setup. If this hap-
pens, start again at Step 1.
• If AC power fails and the backup
batteries become weak, the
remote operation security code
automatically resets to 500.
1. Hold down
CODE/STOP
for about
2 seconds. The display shows the
first digit and the TAD announces,
“First digit”.
2. Repeatedly press
SKIP
or
REPEAT
until the desired digit appears.
3. Press
CODE/STOP
to store the
digit. When you store the first
digit, the display shows the sec-
ond digit and the TAD announces,
“Second digit.”
4. Repeat Steps 2 and 3 to change
the second and third digit.
5. After you change the third digit,
the TAD announces your security
code by saying, “Code is ---.”
Note:
You can check your security
code by pressing
CODE/STOP
.
OPERATING THE TAD
FROM A REMOTE
LOCATION
1. Dial your phone number. Even if
the TAD is not set to answer calls,
it will answer after about 10 rings.
2. After the outgoing message plays
and the TAD beeps, enter your
remote operation security code.
43-724A.fm Page 22 Tuesday, May 16, 2000 4:51 PM