Filter
Top Products
16
Note:
You must enter your selec-
tion within 10 seconds after the
TAD announces the day of the
week, hour and minute. Other-
wise, the current selection aborts
and the TAD exits the program
mode. If this happens, start over.
3. Press
SKIP
or
REPEAT
to adjust
the day. The TAD announces the
day of the week each time you
press the button.
4. Press
TIME
to store the day of the
week you set.
5. Repeat Steps 3 and 4 to store the
hour and the minute.
6. When you press
TIME
after setting
the minute, the TAD beeps and
announces the current day, hour,
and minute.
Notes:
The TAD uses the 12-hour time
format. Be sure to set the correct
AM or PM hour.
To hear the current day of the
week and time, press
TIME
.
SETTING THE NUMBER
OF RINGS
The TAD is preset to ring twice before
it answers the first call. To have it ring
2, 4, or 7 times before answering,
slide
RING SELECT
(located on the
back of the TAD) to
2
,
4
, or
7
( to have
the TAD ring 2, 4,
or 7 times before
answering a call).
TOLL SAVER
To help you avoid unnecessary long
distance charges, you can slide
RING
SELECT
to
TS
(Toll Saver). Once you
select
TS
, if there are new messages,
the TAD answers on the second ring.
If there are no new messages, the
TAD answers on the fourth ring, and
gives you time to hang up before it an-
swers.
RECORDING OUTGOING
MESSAGES (OGM)
You can record three different OGM
types to fit your needs.
Note:
The TAD has a built-in outgoing
message that says, “Hello, please
leave your message after the tone.”
This built-in OGM is available for
OGM 1 and OGM 2 only.
1. Slide
ANNOUNCE SELECT
(located on the back of the TAD)
to
1 (
for OGM 1),
2
(for OGM 2), or
AO
(for Announce Only).
43-724A.fm Page 16 Tuesday, May 16, 2000 4:51 PM