Filter
Top Products
25
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The remote operation security code is
preset to 784, but you can change it by
following these steps.
Note
: Be sure to set each digit within 8
seconds. Otherwise, you must start over
from Step 1.
1. Hold down
CODE
until the TAD
beeps once.
Co
appears.
2. Press
CODE
again.
Sc
(security
code) and the digits of the current
code appear in sequence, then the
first digit reappears.
For example, when the security
code is 784, the display shows
Sc
(security code),
–
7
,
–8
,
–
4
, then
–
7
reappears.
3. Repeatedly press
CODE
or
MEMO
to set the first digit, then
press
ANSWER
. The second digit
appears.
Note
: If you enter an incorrect digit,
press
STOP/T-SET
, then start again
from Step1.
4. Press
CODE
or
MEMO
to set
the second digit, then press
AN-
SWER
. The third digit appears.
5. Press
CODE
or
MEMO
to set
the third digit, then press
ANSWER
.
The TAD sounds a long beep.
To check the remote operation security
code at any time, follow Steps 1 and 2,
then press
STOP/T-SET
to exit.
34.epsi
43-786.fm Page 25 Monday, August 16, 1999 8:02 AM