Filter
Top Products
13
• If the caller hangs up or is silent
for more than 7 seconds, or if the
incoming message is less than 2
seconds in length, the TAD hangs
up and resets to answer the next
call, but does not record a mes-
sage.
• If the TAD answers when the
memory is full, it plays the mem-
ory full announcement and beeps,
waits 7 seconds for any remote
operation commands (see “Using
Remote Operation Commands”),
then hangs up. The TAD cannot
record additional messages until
you delete at least some of the old
ones (see “Deleting Messages”).
USING THE
ANNOUNCEMENT-ONLY
FEATURE
Your TAD’s announcement-only fea-
ture lets you set the TAD to play a mes-
sage for the caller, then automatically
hang up without letting the caller leave
a message.
Note:
When the TAD is set for
announcement-only, you cannot set it
to record calls using the remote com-
mands as described in “Remote
Answer-On.”
Recording the
Announcement-Only
Message
1. Press
ANN ONLY
so the ANN indi-
cator turns on, then press and
hold
OGM
until the TAD beeps
once and the ON LINE indicator
flashes.
2. Release
OGM
and record your
message. Speak into the TAD
from about 12 inches away.
3. When you finish speaking, press
ON/OFF
. The TAD beeps once, the
announcement-only message
plays, then the ON LINE indicator
stops flashing and the TAD beeps
once more. The announcement-
only feature is now on.
Turning Announcement-Only
On/Off
To turn on the announcement-only fea-
ture at any time, press
ANN ONLY
. The
ANN indicator turns on and the TAD
beeps twice.
To turn off the announcement-only fea-
ture, press
ANN ONLY
. The ANN indi-
cator turns off and the TAD beeps
twice.
illustration
43-781.fm Page 13 Monday, August 16, 1999 7:41 AM