Filter
Top Products
11
Recording the Memory Full
Announcement
The TAD has a built-in memory full an-
nouncement. When the memory be-
comes full and the TAD can no longer
record messages, the ON LINE, PLAY,
and MEMO indicators flash, and the
TAD announces to the caller “The
memory is full.”
Follow these steps if you want to
record your own memory full an-
nouncement (up to 1 minute in length).
1. Press and hold
4/OGM2
until the
TAD beeps and the ON LINE indi-
cator flashes.
2. Speak into the TAD in a strong
voice from about 12 inches away.
3. Press
ON/OFF
when you finish
recording the announcement. The
TAD plays the current memory full
announcement.
Checking/Deleting the
Memory Full Announcement
You can press
4/OGM2
at any time to
play the memory full announcement.
Adjust
VOLUME
on the side of the TAD
to a comfortable listening level.
To stop listening to the memory full an-
nouncement before it ends, press
ON/
OFF
.
To delete your recorded memory full
announcement, press
PGM/DEL
while
the TAD is playing it. The TAD beeps
twice and is then set to use its built-in
announcement.
illustration
43-781.fm Page 11 Monday, August 16, 1999 7:41 AM