18
USING REMOTE COMMANDS
To use remote commands, you must enter the remote operation security code within
8 seconds after the TAD answers the call. After the TAD beeps once to verify you
entered the code correctly, you can enter the number(s) for the function(s) you want
the TAD to perform.
Press Command Function
0 Stop Stops messa
e play, messa
e recordin
, and room
monitorin
.
1 Play OGM If an OGM is recorded, the TAD says, “Play
announcement” and plays the out
oin
messa
e.
After the messa
e plays, the TAD beeps once.
If no OGM is recorded, the TAD beeps, then
announces, “No announcement.”
2 Chan
e OGM Records a new out
oin
messa
e. When the TAD
beeps and announces, “Record announcement,”
be
in your new out
oin
messa
e. When you fin-
ish, press
0
. The TAD beeps.
3 Room Monitor Monitors the room where the TAD is located. The
TAD announces, “Room Monitor.” After 30 sec-
onds, the TAD beeps and monitorin
stops. To stop
monitorin
the room sooner, press
0
.
4Play All Messa
es (To
see what commands
you can use at this
point, see the table on
Pa
e 19.)
Plays all the recorded messa
es.
If messa
es are recorded, the TAD beeps, then
announces the number of new messa
es before
playin
them.
If no messa
e is recorded, the TAD beeps and
says, “No messa
e.”
43-743.fm Page 18 Friday, August 13, 1999 2:05 PM
