Filter
Top Products
10
4. Route the adapter’s cord through
the strain relief slot on the bottom of
the bracket.
5. Plug the adapter into a standard AC
outlet.
6. Connect the phone cord(s) to the
modular phone line jack(s).
7. Raise the base’s antenna to a verti-
cal position.
On a Wall Plate or a Wall
Note:
To mount the base directly on the
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the bracket. Drill two
holes 3
15
/
16
inches apart. Then thread a
screw into each hole, letting the heads
extend about
5
/
16
inch from the wall.
1. Insert the two tabs at the top of the
wide end of the supplied bracket
into the base’s lower tab slots as
shown, then press down on the
bracket’s latches and insert them
into the clip slots.
2. To connect the phone to a two-line
phone jack, plug one end of the sup-
plied long modular cord into the
TEL
LINE 1/2
jack on the back of the
phone.
Note:
If you connect the phone to a
two-line phone jack with a two-line
cord, do not connect a cord to the
TEL LINE 2
jack or the phone will not
operate properly.
To connect the phone to two one-
line phone jacks, plug one end of
the supplied short two-line modular
cord into
TEL LINE 1/2
and plug
another cord (not supplied) into the
TEL LINE 2
jack.
To connect the phone to a single
one-line phone jack, plug one end of
the supplied long modular cord into
the
TEL LINE 1/2
or
TEL LINE 2
jack.
Note:
If you connect the phone to a
single one-line phone jack, avoid
pressing the unused line button or
you might hear feedback.
43-685.fm Page 10 Thursday, July 8, 1999 7:50 AM