Filter
Top Products
Phonebook
32
5. Press the number keypad to enter the
phone number (up to 20 digits), press
the OK soft key to store the number. Ô
6.
Distinctive Ring
appears. Press
VOL/RING/ or VOL/RING/ to move
the pointer to one of the Distinctive
Ring options, and then press the
OK
soft key. Ô
7.
Speed Dial
appears. Press
VOL/RING/ or VOL/RING/ to move
the pointer to select the Speed dial
location (ten locations: SPD1-SPD0).
Ô
8. Press the
OK soft key. You will hear a
confirmation tone, and
Done!
appears
in the display.
STEPS FOR ENTERING NAMES
AND
SPECIAL CHARACTERS
Refer to the letters on the number keys to
select the desired characters. With each
press of a number key (
0-9), the displayed
character appears in the following order:
upper case letters first, lower case letters
next and finally the number corresponding
to the key.Ô
Ô NOTES Ô
Storing Phone Numbers,
Names, Distinctive Rings,
and Speed Dial
• The pause key counts as
one digit. Pressing the
PAUSE soft key, more
than once increases the
length of the pause
between numbers. Each
pause represents a two
second delay.
• If you choose not to
store a “Distinctive
Ring”, simply select the
“No Selectn” option.
• Selecting a speed dial
location where a number
is already stored,
releases the old
number’s speed dial
setting. The new number
will be stored in the
speed dial location.
• If you choose not to
store the name/number
as a Speed Dial, simply
select the “No Selectn”
option.
Steps for Entering Names
and Special Characters
• If the next character
uses the same number
key, you must press #/>
to move the cursor over.
Otherwise the next time
you press the number
key, it changes the
character that was
previously set.
Number of times key is pressed