Filter
Top Products
The Integrated Answering Device
31
Then the system announces the guidance for
setting the PIN code.
2. Press
VOL/SEL/# or VOL/SEL/$ until the
desired number appears.
3. Press
SET/RING to select the PIN code. You
hear a confirmation tone, then the
announcement “Security code” and the new
PIN code is announced. After a few seconds,
the system announces “To set ring time, press
menu again”.
Setting the ring time
The ring time setting allows you to set the number
of rings the caller hears before your answering
system plays the outgoing message. You can set
the ring time to answer after two, four, or six rings.
Setting (Toll Saver), the answering system picks
up after two rings if you have new messages, and
after four rings if there are none. This way, if you
make a long distance call to check your messages,
you can hang up after the second ring to avoid
billing charges.
1. Press
MENU three times in standby mode.
You hear “Ring time” and the current ring time
([ ] 2, [ ] 4, [ ] 6, [ ] Toll saver), and it is
displayed on the base. Then you hear the
guidance for setting the ring time.
2. Press
VOL/SEL/# or VOL/SEL/$ until the
desired ring time appears.
3. Press
SET/RING to select the new ring time. You
hear a confirmation tone, then the
announcement “Ring time” and the new ring
time is announced. After a few seconds, the
system announces “To set record time, press
menu again”.
43-3827/3870.FM Page 31 Monday, June 2, 2003 11:02 AM