Filter
Top Products
Operation
15
call. For example, entering your bank account
number after you have called your bank. Ô
Initially make your call with the pulse dialing mode.
Once your call connects, press
∗/TONE/&. Enter
the desired number. These digits will be sent as
tone dialing. Once the call ends, the tone mode is
canceled and pulse dialing mode resumes.
TRAVELING OUT-OF-RANGE
During a call, as you begin to move your handset
too far from your base unit, noise increases. If you
pass the range limits of the base unit, your call will
terminate within 5 minutes.
SELECTING A DIFFERENT CHANNEL
If you encounter interference while using your
phone, you can manually change the phone’s
channel for clear operation. This function works
only when the phone is in use.
Press
CH/DEL. SS
SS
cc
cc
aa
aa
nn
nn
nn
nn
ii
ii
nn
nn
gg
gg
appears on the display,
indicating the phone is changing to another
channel.
PAGE
To locate the handset (while it’s off the base), press
PAGE on the base. The handset beeps for 60
seconds.Ô
Paging is canceled when pressing any handset key,
PAGE on the base or the handset is returned to the
base.
FLASH AND CALL WAITING
If you have “Call Waiting” service and a call waiting
tone sounds while you are on a call, press
talk/
FLASH to accept the waiting call. There is a short
pause, then you will hear the new caller. To return
to the original caller, press
talk/FLASH again.Ô
Ô NOTE Ô
Tone Dialing Switch Over
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number can
be stored in a memory
location. This is referred
to as Chain Dialing (See
page 19.)
Page
• Paging is also canceled
when the phone receive
an incoming call.
Flash and Call Waiting
• You must subscribe
through your local
telephone company to
receive Call Waiting
Service.
43-3827/3870.FM Page 15 Monday, June 2, 2003 11:02 AM