Filter
Top Products
SoundStation2 Direct Connect User Guide - 22
blink red to indicate the hold state and
the display will show “Line in Use”
until the handset is returned to the
cradle, then return to the green steady
state.
The call will be active on the
conference phone and all functions
will be as defined for calls initiated on
the conference phone.
Conferencing - using the Meridian phone:
Conference calls already established
on the Meridian phone can be easily
transferred to the SoundStation2 Direct
Connect.
► Press the ON/OFF button on the
conference phone then replace the
Meridian handset. The LEDs will
blink red to indicate the hold state
and the display will show “Line in
Use” until the handset is returned
to the cradle, then return to the
green steady state.
The SoundStation2 Direct Connect will
function as if the conference call had
originated on the conference phone. If
the ECS limit has not been reached, new
parties may be added as described earlier.
Transferring conferences before
the cycle is complete, such as
before the call is established, and
included or dropped, will result
in dropping all callers if you
subsequently push the ON/OFF
button on the conference phone.
Call Mute - using the Meridian Phone:
If you have a Meridian phone
connected to the Interface Module,
and your SoundStation2 Direct
Connect is in use, you may use your
phone to break away from the public
conference call to speak privately to
the far end(s) without disconnecting
the conference call.
► When you lift the handset, all
microphones and the speaker
on the console are muted. The
red LEDs will blink to indicate
the hold state and the display
will show “Line in Use”
. When
the handset is returned to the
cradle, the conference call is
resumed and the LEDs return to
a steady state.