Filter
Top Products
15
PHONEBOOK
14
TIP
USING THE PHONEBOOK
Phonebook allows you to dial a number
using just a few key presses. It stores
names/numbers in the Phonebook memory
location, and you can search names in
alphabetical order. You have a total of 100
locations that can be used for the
Phonebook (including the Speed dials) and
Caller ID messages.
If any of the following occurs while using
the Phonebook function, operation will be
canceled.
• Press END. The phone will return to the
standby mode (or the call will be
disconnected).
• Press TALK/FLASH.
• Place the remote in the base.
• Press DELETE, or receive an incoming call
or PAGE (from the standby mode only).
• Receive a CIDCW (Caller ID on Call
Waiting) (during a call only).
If the remote
remains idle for
30 seconds, the
phone will return
to the standby
mode (or back
to the call).
FLASH AND CALL WAITING
If you have Call
Waiting service and
a call waiting tone
sounds while you are
on a call, press
TALK/FLASH to
accept the waiting
call. There is a short
pause, then you will
hear the new caller. To return to the original
caller, press TALK/FLASH again.
You must
subscribe
through your
local
telephone
company to
receive Call
Waiting Service.
The message
waiting LED on the
remote is designed
to work with your
voice mail service
provided by your
local telephone company. The LED flashes
when you have new incoming messages in
the voice mail service.
You may need to occasionally reset the
indicator if it remains On after you’ve
retrieved your messages. To reset the
indicator, when the phone is in the standby
mode press and hold PAGE on the base until
the paging sound stops (about 5 seconds).
TIP
MESSAGE LED
CT11-12_020904 2/13/04 10:47 AM Page 14