Filter
Top Products
4
TIP
5
AREA CODE allows you to enter your local
area code so CID will not show the area
code from local callers. See the next page
for area code instructions.
To change your Caller ID options:
1) When the phone
is in the standby
mode, press
MENU/MUTE.
2) Press ▲ or ▼ to
move the pointer
to “Caller ID
Setup”, then press SELECT/CH.
3) Press ▲ or ▼ to
choose “Auto
Talk” or “CIDCW”,
then press SELECT/CH.
4) Press ▲ or ▼ to change the selection.
AutoTalk: “Auto Talk
On” or “Auto Talk
Off”
CIDCW: “CIDCW
On”, “CW Deluxe
On” or “CIDCW Off”
5) Press SELECT/CH, and you will hear
a confirmation tone.
6) Press END to exit.
Standby Mode:
The remote is
not in use, is off
the base, and
TALK/FLASH
has not been
pressed. A dial
tone is not
present.
TIP
TIP
ENTERING YOUR AREA CODE
If you enter a 3-digit area code number in
the “Area Code” option, your local area
code does not appear in Caller ID messages.
For calls received from outside your local
area code, you will see a full 10-digit
number.
1) When the phone
is in the standby
mode, press
MENU/MUTE.
2) Press ▲ or ▼ to
move the pointer
to “Caller ID
Setup”, then
press SELECT/CH.
3) Press ▲ or ▼ to
move the pointer
to “Area Code”,
then press
SELECT/CH.
4) Use the number
keypad (0 to 9)
to enter a 3-digit
area code.
5) Press SELECT/CH, and you will hear
a confirmation tone.
6) Press END to exit.
If your calling
area requires
10-digit dialing,
do not program
this option.
If the area code
has already been
stored in
memory, the
stored area code
will be displayed
in this mode. To
change it, press
delete and the
number keypad
to enter the new
area code.
BASICS
CT11-12_020904 2/13/04 10:47 AM Page 4