Filter
Top Products
11
TIP
10
TIP
“Distinctive Ringer” allows you to preset
memory locations with a designated ring
tone. When an incoming call is received
and the Caller ID information matches the
information in one of the memory locations,
the Distinctive Ring that has been stored for
that particular caller will sound.
If you have set multiple memory locations
with distinctive rings, switching the setting to
“Distinctive Off” will result in no distinctive
ringing. All incoming calls will have a normal
ring tone. Switching to “Distinctive On” will
activate all programmed distinctive ring
memory locations.
1) When the phone is
in the standby
mode, press
MENU/MUTE.
2) Press
▲ or ▼ to
move the pointer to
“Distinct. Ring”,
then press
SELECT/CH.
3) Press
▲ or ▼ to choose “Distinctive On”
or “Distinctive Off”.
4) Press SELECT/CH, and you will hear a
confirmation tone.
5) Press END to exit.
DISTINCTIVE RINGER SETUP
See ”Storing
Phone Numbers,
Names,
Distinctive Rings,
and Speed Dial”
on page 17 for
storing a
Distinctive Ring
in the Phonebook.
A
DJUSTING THE
HEADSET VOLUME
The remote headset volume settings (Volume
Low, Volume Medium, Volume High, and
Volume Maximum) can only be adjusted
during a call. Press
▲ or ▼ to select the
volume setting. When you hang up, the
phone keeps the last volume setting
selected.
MUTE M
ICROPHONE
You can temporarily
turn Off the micro-
phone so that the
person you are talking
with cannot hear you.
1) During a telephone
call press and hold
MENU/MUTE for a
few seconds to turn
Off the microphone, and “Mute” appears
on the display.
2) Press MENU/MUTE again to cancel muting.
When you press
▲ in maximum
volume level or
▼ in lowest
volume level,
an error tone
sounds.
Do not press
END to cancel
muting. END will
disconnect the
call and the
phone will return
to standby mode.
BASICS
TIP
CT11-12_020904 2/13/04 10:47 AM Page 10