Filter
Top Products
UNIVERSAL DOCKING STATION USER’S GUIDE
7
If the LED is solid red, LP1 is already in use by wireline telephone service.
Immediately disconnect the wireline telephone service at the network interface box
or move the line switch on back of unit to LP2. If the LED is now flashing green, any
telephones to be used must be connected to the second pair of wires in the home.
5. If the LED is red when the switch is positioned at LP2, then wireline service is
also connected to this pair of wires. You should have a qualified phone service
technician disconnect the wireline telephone service at the network interface box
to use this pair of wires.
*Note: A wireline telephone connection to the local telephone company central
office may be present even if no wireline telephone service is being purchased. If
the LED is red, this indicates that a wireline is still present, whether or not dial
tone is present. The LED must be flashing green in order for the Dock-N-Talk™ to
work prior to the connection of your cell phone. Only connect the cell phone
handset to the Dock-N-Talk™ if the LED is flashing green and note which setting,
LP1 or LP2, has been set. The telephones must be connected to the same set of
wires as the Dock-N-Talk™ setting in order to be able to dial out on the
telephones and have them ring for incoming calls. See LED Status section above.
Extension Telephone Sets
You may have up to five extension telephones connected through your internal wiring to
the same pair of wires connected to the Dock-N-Talk™. This will allow you to place cell
phone calls and receive cell phone calls from those extension telephones. The extension
telephones can be connected using your existing telephone wiring as if you had local
wireline telephone service.