Filter
Top Products
30 Advanced settings
If no base is found within a certain period,
NO BASE
will be displayed with an error
tone to indicate failed registration and the
handset returns to idle mode.
8.3 Unregister
Press
m key in idle mode, scroll
: to
ADVANCED SET
and press
<
OK
, scroll : to
UNREGISTER
and press <
OK
.
Enter the Master PIN when
prompted and
CONFIRM?
is
displayed on the screen. Press
<
OK
to confirm.
Scroll
: to select the handset
number to unregister and press
<
OK
.
• A validation tone is emitted to indicate
successful unregistration and the
screen returns to previous menu.
Note
If no action is taken on the handset within
15 seconds, the unregistration procedure
will be aborted and the handset returns
to idle mode.
To unregister a handset that does not
belong to your new phone range, you can
only use your new phone to unregister it.
8.4 Country selection
The availability of this menu is dependent
on your country. You can select another
country different from the one chosen
during WELCOME mode.
Note
Once the country is selected, the default
line settings for the selected country will
be applied to the phone automatically (e.g.
Recall time, Dial mode, Language, etc).
Press
m key in idle mode, scroll
: to
ADVANCED SET
and press
<
OK
, scroll : to
COUNTRY
and press <
OK
.
Enter the Master PIN when prompted
and press
<
OK
to confirm.
Note
By default, the Master PIN is 0000.
Scroll
: to the country of your
choice and press
<
OK
to confirm.
• A validation tone is emitted and the
screen returns to previous menu.
8.5 Reset unit
You can reset your phone to its default
settings with this feature.
Warning
Upon reset, all your personal settings, call
log and redial list entries will be deleted
and the phone will return to its default
settings. However, your phonebook will
remain unchanged after reset.
Note
You may have to configure your phone
once again. In this case the WELCOME
mode will appear again after master reset.
(see chapter 3.4)
Press
m key in idle mode, scroll
: to
ADVANCED SET
and press
<
OK
, scroll : to
RESET
and
press
<
OK
.
CONFIRM?
is displayed on the screen.
Press
<
OK
again
to confirm.
• A validation tone is emitted.
• The unit is reset to its default
settings. (see “Default settings” on
chapter 8.10)
1
2
3
1
2
3
!
1
2
3
cd155_ifu_master_uk.book Page 30 Tuesday, February 12, 2008 5:44 PM