Filter
Top Products
1.4 During a Conversation
52 User Manual
Holding in a System Parking Zone (Call Park)
You can put a call on hold in a common parking zone of the PBX so that any extension can retrieve the
parked call. Up to 10 calls can be parked in the PBX.
To park a call
•*
1
You may have to enter the Call Hold feature number after pressing the Recall/
hookswitch on your single line telephone (SLT), depending on the SLT Hold Mode of your
PBX.
Call Hold feature number:
– Plan 1: 20 (United Kingdom/New Zealand: 50)
– Plan 2/Plan 3: #20 (United Kingdom/New Zealand: #50)
Ask your manager or dealer about the mode assigned to your PBX.
•*
2
Enter "#59" when "Plan 2" or "Plan 3" is selected as the numbering plan through system
programming.
•*
3
Enter "#5" when "Plan 2" or "Plan 3" is selected as the numbering plan through system
programming.
• The CO or INTERCOM button light shows the current status as follows:
— General Call Hold mode
Flashing green slowly: You have a call on hold.
Flashing red slowly: Another extension has a call on hold.
— Exclusive Call Hold mode
Flashing green at moderate speed: You have a call on hold.
Red on: Another extension has a call on hold.
• Hold Mode Change (proprietary telephone [PT] only)
Pressing the HOLD button again while a call is on hold switches the status from General
Call Hold mode to Exclusive Call Hold mode, or vice versa.
• You cannot hold doorphone calls.
• An SLT user can hold either one intercom call or one outside (CO) line call at a time, while
a PT user can hold one intercom call and multiple outside (CO) line calls. To hold multiple
calls, use the Call Park feature.
Dial parking
zone number (0–9).
During a conversation
PT/SLT
On-hook.
Enter 22.
parking zone no.
22
C.ToneC.Tone &
D.Tone
Press HOLD or
Recall/hookswitch.
OR
*
1