Troubleshooting
25
Troubleshooting
The icon is not blinking
when the handset is placed on
the base
PROBLEMS
No dialling tone
Crackling on the line
The handset displays ‘not
available’
- when attempting to add
another handset to the base
station
- when using a handset
Noise interference on your radio
or television
Caller Line Identification (CLI)
service does not work
No ring tone
The icon does not appear
The icon is blinking
- Bad battery contact
- Dirty contact
- Battery is full
CAUSES
- No power
- Batteries are empty
- You are too far from the base station
- Wrong line cable
- Line adaptor (when needed) not
connected to the line cord
- The ring tone is deactivated
- No mains power
- The handset is too far from the
base station
- Handset not registered to the
base station
- You are too far from the base
station
- The base station is too close to
electrical appliances,reinforced
concrete walls or metal
doorframes
- The procedure to add a handset
has failed,try again
- Maximum number of handsets
(5) has been reached
- Base station is already busy with
another handset
The DECT 122 base station or
mains power pack are too close
to electrical appliances
- The service is not activated
- Move the handset slightly
- Clean the contact with a cloth
moistened with alcohol
- No need to charge
SOLUTIONS
- Check the connections.
Reset the phone :unplug and
plug back in the mains
- Charge the batteries at least 24
hours
- Move closer to the base station
- Always use the line cable
provided
- Connect the line adaptor (when
needed) to the line cord
- Increase the volume (page 18)
- Check connections
- Move closer to the base station
- Register the handset to the
base (page 22)
- Move closer to the base station
- Move the base station to find a
better place (the higher the
better)
- Disconnect and connect the
base station power supply.
- Remove and place back the
handset battery
- Follow the procedure to
register a handset (page 22)
- Unregister a handset
- Wait until it is available
Move the power pack or base
station as far away as possible
- Check your subscription with
your network operator
Telephone troubleshooting
www.philips.com/support
A phonebook entry cannot be
stored
The phonebook is full
Delete an entry to free memory
DECT122_GBIE_09.qxd 27.09.2005 17:06 Seite 25