Filter
Top Products
5
INSTALLATION
3 Connect the power cord.
• Plug the power adapter into the jack labeled 11V DC on the
back of the base.
• Run the cord under the tab on the bottom of the base unit and
under the tab on the wall mounting base.
• Plug the AC adapter into an electrical outlet not controlled by a
wall switch.
4 Connect the telephone line cord.
• Using the short telephone line cord supplied, insert one end of
the telephone line cord into the telephone jack on the back of
the base.
• Feed the excess line cord under the tab on the bottom of the
base.
• Plug the line cord into the standard wall jack.
5 Mount the telephone on the wall.
Position the telephone base so the mounting studs on the wall jack
fit into the base of the telephone. Slide the telephone down on the
mounting studs until the phone locks into place.
6 Follow Steps 6 and 7 under Table/Desk Installation.
CAUTION: Use only the AC power adapter supplied with this
telephone, Power Supply for 9125. Input: AC 117V, 60 Hz, 12W
Output: DC 11V, 500mA.
Belt Clip
If you wish, you can attach the belt clip to the cordless handset, following
the illustrations below.
To RemoveTo Attach
Lucent 9125 book.L1 4/8/98, 11:25 AM5