Filter
Top Products
4
4 Connect the telephone line cord.
Plug one end of the telephone line cord into the jack on the back of
the base. Plug the other end of the line cord into a modular jack.
Make sure the plugs snap firmly in place.
5 Connect the power cord.
Plug the power adapter into the jack labeled 11V DC on the back of
the base. Plug the AC adapter on the power cord into an electrical
outlet not controlled by a wall switch. The POWER light on the base
goes on.
6 Charge the handset batteries for 16 hours.
Place the handset face down or face up in the base. The CHARGING
light on the base goes on to show the handset is in the right position
to charge the batteries.
7 Check for dial tone.
After the batteries are charged, pick up the handset and extend the
base antenna. Check for a dial tone by pressing P, you should
hear a dial tone.
Wall Installation
INSTALLATION
1 Follow Steps 1–3 under Table/Desk Installation.
2 Turn the base unit over, and attach the wall mounting base to
the lower half of the base unit. Gently press down until it snaps
firmly into place.
Lucent 9125 book.L1 4/8/98, 11:25 AM4