Filter
Top Products
3
INSTALLATION
Table/Desk Installation
1 Choose a spot near an electrical outlet and a telephone jack.
This phone requires a modular telephone jack and a standard electrical
outlet (110v AC). The outlet should not be controlled by a wall switch.
2 Install the handset battery.
(For an illustration of battery installation, see BATTERIES in this manual.)
• Remove the battery cover by pressing on the indentation and
sliding downward.
• Install the battery pack so that the metal contacts on the bottom
of the battery are aligned with the charging contacts in the
battery compartment.
• Replace the battery cover by sliding it on its track up over the
battery compartment until it snaps firmly in place.
3 Set the dial mode.
If you have touch tone service, set the switch on the bottom of the
base to TONE. If you have dial pulse (rotary) service, set the switch
to PULSE. Even if you have dial pulse service, you can still use
telephone services requiring tone signals. See “Temporary Tone” in
the OPERATION section of this manual.
Telephone
Line Jack
Modular
Telephone
Jack
Standard
Electrical
Outlet
Power Cord
Telephone Line Cord
Lucent 9125 book.L1 4/8/98, 11:24 AM3