Filter
Top Products
3. Configuration Using the Web Interface
3-16 June 2004 8900-A2-GB20-30
Configuring ATM Ports
Use the Configuration - ATM Port screen to associate a DSL port or the T1/E1 port
with an ATM segment location. ATM segment location ID is a 16-octet field that
identifies this ATM interface for OAM F5 loopbacks. When a segment F5 OAM
loopback cell is received, the destination segment location in the cell is compared
to the segment location ID for the port. If the destination location ID matches the
location ID or is all ones, the cell is looped back to the source. If there is not a
match, the cell passes through the card.
Procedure
To associate a port with an ATM segment location:
1. Select a Slot and Port from the drop-down lists, and click on Select.
2. Enter an ATM Segment Location ID. The value must be 32 hexadecimal
characters or ALLONES. Allowed values are restricted per ITU-T1.610 as
follows:
— The first byte must be 01, 02, 03, FF or 6A.
— If the first octet is FF, then octets 2–16 must also be FF.
— If the first octet is 6A, then octets 2–16 must also be 6A.
3. Click on Apply.