Filter
Top Products
Useful Information
For assistance, please visit http://www.panasonic.com/consumersupport 27
Specifications
Speakerphone unit
Operating environment:
5 °C – 40 °C (41 °F – 104 °F)
Dimensions:
Approx. height 64 mm x width 279 mm x
depth 279 mm (2
17
/
32
" x 11" x 11")
Mass (Weight):
Approx. 970 g (2.14 lb.)
Audio Out:
Typical: Approx.
−3 dBm (at 10 kΩ),
0.03 mW
Maximum:Approx. 0 dBm (at 10 kΩ),
0.06 mW
ø3.5 mm mono mini jack
Power consumption:
Standby: Approx. 4.0 W
Maximum: Approx. 7.0 W
Power supply:
AC adaptor (120 V AC, 60 Hz)
Interface box
Dimensions:
Approx. height 32 mm x width 67 mm x
depth 76 mm (1
1
/
4
" x 2
5
/
8
" x 3")
Mass (Weight):
Approx. 60 g (0.13 lb.)
Note:
LDesign and specifications are subject to
change without notice.
LThe illustrations in these instructions
may vary slightly from the actual
product.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
CAUTION:
A
ny changes or modifications not
expressly approved by the party
responsible for compliance could void
the user’s authority to operate this
device.
NOTE:
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
− Reorient or relocate the receiving
antenna.
− Increase the separation between the
equipment and receiver.
− Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
− Consult the dealer or an experienced
radio/TV technician for help.
TS730S.book 27 ページ ２００５年７月１９日 火曜日 午後１時５９分