Filter
Top Products
Programmable Settings
For assistance, please visit http://www.panasonic.com/consumersupport 17
Programming via direct commands
You can program features using “direct commands”– special codes that take you directly
to the feature you wish to program and allow you to select the desired setting. There is no
need to scroll through the unit’s sub-menus.
Details of each feature can be found on the corresponding pages.
Important:
LBefore programming, make sure the unit is not being used.
1 Press {MENU} ({F2} key).
2 Press {#}.
3 Enter the desired feature code (shown below).
4 Enter the desired setting code (shown below).
LThis step may vary depending on the feature being programmed.
5 Press {SAVE} ({F3} key).
6 Press {STOP} to exit programming mode.
Note:
LIf the unit beeps 5 times, you entered an invalid code. Enter the correct code.
LIf you make a mistake or enter the wrong code, press {CLEAR}.
Direct commands chart
Note:
LThe default settings are indicated by *.
Feature Feature code Setting code Page
Ringer volume {1} {6} {0}{1}: Low {2}: Medium
{3}: High* {0}: Off
page 19
Ringer tone {1} {6} {1}{1}–{3}: Tone pattern 1*–3 page 19
LCD contrast {1} {4} {5}{1}–{6}: Level 1–6
(Default: 3)
page 19
Key tone {1} {6} {5}{1}: On* {0}: Off page 20
Caller ID number auto edit {2} {1} {4}{1}: On* {0}: Off page 20
Set dial mode {1} {2} {0}{1}: Pulse {2}: Tone* page 8
:
Enter direct No.
BACK
TS730S.book 17 ページ ２００５年７月１９日 火曜日 午後１時５９分