Panasonic KX-TS600W Telephone User Manual


 
Settings
14
For assistance, please visit http://www.panasonic.com/phonehelp
Caller ID Number Auto Edit
Once you call back an edited number (p. 23), this unit can automatically edit
incoming phone numbers from the same area code in the Caller List and
each time you receive a call. For example, it can ignore the area code of
calls originating from your area code, so that you can call these numbers
from the Caller List without dialing the area code. This function only
applicable for 10 digits of incoming number only. Other than 10 digits phone
number, the Auto Edit will not be performed by the set for call back function.
To activate this feature, you must edit a caller’s phone number in the
Caller List (p. 23) by selecting pattern , or , then make a call to that
number. Calls from numbers in that area code will be edited automatically.
The unit can remember up to 4 area codes to be edited according to
pattern and .
When more than 5 area codes are edited, older area codes are reset to
pattern . Phone numbers from the 4 most recently edited area codes will
be automatically edited. You can turn this feature on or off. The factory
preset is ON.
To turn Caller ID Number Auto Edit On or OFF.
1
Press [FUNCTION/EDIT].
2
Scroll to “Program ?” by pressing [4]
or [
3]. Press [OK] (Yes key).
3
Scroll to “Set auto edit ?” by
pressing [
4] or [3].
4
Press [OK] (Yes key).
5
Select “Off” or “On” by pressing [4] or
[
3].
6
Press [OK] (Save key).
A long beep sounds.
The display will return to step 3. To exit the programming mode, press
[EXIT] or wait for 60 seconds.
If you fail to reach your destination when making a call, the phone number you
dialed might have an incorrect pattern. Edit the phone number with another
pattern (p. 23).
When this feature is turned off, the unit will still be able to display Caller ID, but
incoming Caller ID numbers will not be automatically edited.
If you move to another area, you may need to turn this feature off to erase the
previously edited area codes. To use this feature again, turn it on and reprogram
the area codes you want to edit once again.
Set auto edit ?
34
[OK]=Yes
Auto edit
:On
34
[OK]=Save
TS600W.book Page 14 Friday, October 28, 2005 2:10 PM