Filter
Top Products
44
For assistance, please visit http://www.panasonic.com/phonehelp
If “ ” flashes, the battery power is low. Install new batteries as soon as
possible. If batteries are not replaced even after the “ ” is displayed, the
unit may not work properly.
• Store the desired items in the Phonebook or Direct Dial memory, because after
the battery replacement, the information stored in the Redial List will be cleared.
1
Disconnect the telephone line
cord from the unit.
2
Press down in the direction of the
arrow and open the cover (1).
3
Replace the batteries with new
ones using correct polarity (+, –)
(2), and close the cover.
4
Connect the telephone line cord
to the unit.
• The time will be shown as “12:00AM 12/31” or “0:00 12/31” and “ ” will
flash after replacing the batteries, readjust the time and date.
Battery Precautions:
The batteries should be used correctly, otherwise the unit may be damaged by
battery leakage.
— Do not mix different types of batteries.
— Do not charge, short-circuit, disassemble, heat or dispose of in fire.
— Remove all the batteries when replacing.
Note:
— If you do not install the batteries or if the battery power is low, the time will be
shown as “12:00AM 12/31” or “0:00 12/31” and “ ” will flash.
Readjust the time after the battery replacement.
— Replace all the batteries every six months if using Alkaline batteries, or
misoperation may occur. (When you use Manganese batteries, replace all of
them every three months.)
— Do not use nickel-cadmium batteries.
Battery Replacement
TS600W.book Page 44 Friday, October 28, 2005 2:10 PM