Filter
Top Products
For assistance, please call: 1-800-211-PANA(7262)
41
Listening to Messages
Answering System
Using the Handset (Remote Operation)
To play back messages
*If you press
[STOP]
on the base unit during message playback, operation is
stopped.
To resume the playback, press
[MESSAGE/SLOW TALK]
on the base unit within
15 seconds, or the voice menu will start (see below).
• If noise interferes with the message playback:
— during playback using
[]
, press
[]
(Channel).
— during playback using
[]
, press
[]
(Channel).
The unit selects a clearer channel.
• At the end of the last message, “
End of final message
” is heard. The unit will
announce the remaining recording time if it is less than 3 minutes.
• If the unit starts to ring during the remote operation, press
[]
or
[]
to answer
the call. To playback, start again from the beginning after hanging up.
• If you hear “
Memory full
” after playback, erase unnecessary messages (p. 43).
Voice menu
If you do not press any buttons at the end of the last message, the unit will
announce “
End of final message
” and the voice menu will begin.
The unit announces, “
Press 4 to play back new messages. Press 5 to play back all
messages
.”
• You can press buttons for other options (p. 42) even if the voice menu has started.
• If you do not press any buttons within 10 seconds, the handset will exit remote
operation.
1
Press
[MENU]
.
2
Scroll to “
Message play
” by pressing
[]
or
[]
, then press
Select
.
• The unit announces the number of new messages
and only new messages are played back.
• The messages will be heard from the speaker. To
switch to the receiver, press
[]
. To switch back
to the speaker, press
[]
.
•
[MESSAGE/SLOW TALK]
,
[REPEAT]
,
[SKIP]
and
[STOP]
* can also be used during playback
(p. 42).
•
When you have no new messages,
the unit
announces “
No new messages. All message playback
”
and plays back all messages.
•
When you have no messages,
the unit
announces