Filter
Top Products
To use the phonebook:
M
N or MFN ( ) a MbN: Select the
phonebook entry. a MOKN 2 times
5 To save the message, select “Yes”. a
MOKN
6 To send the message, press MOKN.
R To cancel sending, press MeN.
Note:
R This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS service
provider/telephone company. Contact your
SMS service provider/telephone company
for details.
R If your message contains over 160
characters, the message is a long message
and “IILong TextII” is displayed. Your
service provider/telephone company may
treat long messages differently from other
messages. Contact your service provider/
telephone company for details.
R If your phone is connected to a PBX, store
the PBX line access number (page 38).
Editing/sending a saved message
1 M
N (right soft key) a a MOKN
2 MbN: “Send List” a MOKN
3 To read a saved message, press MCN or
MDN to select the message. a MOKN
4 To edit the message:
M
N a MbN: “Edit Message” a
MOKN a Continue from step 3, “Writing
and sending a new message”, page 36.
To send the message:
M
N a MbN: “Send” a MOKN a Press
and hold MCN to erase all numbers. a
Continue from step 4, “Writing and
sending a new message”, page 36.
Erasing saved messages
1 M
N (right soft key) a a MOKN
2 MbN: “Send List” a MOKN
3 MbN: Select a message. a MOKN
4 M N a MbN: “Erase” a MOKN
R To erase all messages, select “Erase
All”. a MOKN
5 MbN: “Yes” a MOKN a MeN
Receiving a message
When an SMS message is received:
– “Receiving SMS Message” is displayed.
– a tone is heard (if the handset ringer is
turned on).
–
is displayed with the total number of
new (unread) SMS messages.
Reading a received message
1 M
N (right soft key) a a MOKN
2 MbN: “Receive List” a MOKN
3 MbN: Select a message.
R Messages which have already been
read are indicated by a “
”, even if
they were read using another handset.
R To erase a message, press M
N. a
MbN: “Erase” a MOKN a MbN: “Yes”
a MOKN
4 Press MOKN to read the message content.
Note:
R To call the message sender, press M
N.
Replying to a message
1 While reading a received message, press
M
N.
2 MbN: “Reply” a MOKN
3 Enter a message (page 46). a MOKN
4 Edit the destination phone number if
necessary. a MOKN
5 Continue from step 5, “Writing and
sending a new message”, page 36.
Editing/forwarding a message
1 While reading a received message, press
M
N.
37
SMS (Short Message Service)
TG7851_61FX(en)_0215_ver011.pdf 37 2013/02/15 18:28:13