Filter
Top Products
2 MbN: Select the desired setting. a MOKN
R If you select “Off”, press MeN to
exit.
3 Enter the desired hour and minute you
wish to start this feature. a MOKN
R You can select 24-hour or 12-hour
clock format (“AM” or “PM”) by
pressing *.
4 Enter the desired hour and minute you
wish to end this feature. a MOKN
5 MeN
R When the night mode is set,
is
displayed.
Changing the start and end time
1 M
N (right soft key) #237
2 Continue from step 3, “Turning night
mode on/off”, page 29.
Setting the ring delay
This setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select “No Ringing”,
the handset never rings during night mode.
1 M
N (right soft key) #239
2 MbN: Select the desired setting. a MOKN
a MeN
Note:
R When the answering system answers the
call, this feature does not work.
(KX-TG7861 series: page 3)
Changing the handset name
Each handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1 M
N (right soft key) #104
2 Enter the desired name (max. 10
characters; page 46).
R If not required, go to step 3.
3 MOKN
4 MbN: Select the desired setting. a MOKN
2 times
5 MeN
Incoming call barring (Caller ID
subscribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit emits no sound to the caller, and
disconnects the call.
Important:
R When the unit receives a call from a
number that is stored in the call barred list,
the call is logged in the caller list
(page 34) with after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the
call barred list.
Important:
R You must store the phone number with an
area code in the call barred list.
n From the caller list:
1 MCN (
)
2 MbN: Select the entry to be barred. a
M
N a M N
3 MbN: “Save CID” a MOKN
4 MbN: “Caller Barred” a MOKN
5 MbN: “Yes” a MOKN a MeN
n By entering phone numbers:
1 M
N (right soft key) #217 a
M N
30
Programming
TG7851_61FX(en)_0215_ver011.pdf 30 2013/02/15 18:28:12