Filter
Top Products
– Caller list
– Voice mail messages
– Call restrict
R The following items will be retained:
– Display language
– Date and time
– Handset name
– Repeater mode
– Recordings, including your greeting
message and caller messages
(KX-TG7861 series: page 3)
– Call screening (KX-TG7861 series:
page 3)
– Call barred list
– Shared phonebook
R If you select the desired country in step 2,
the following default settings will be
changed for the selected country’s default
settings:
– Recall/flash time (page 26)
– Message centre 1 and 2 (page 24)
– SMS on/off (page 24)
R According to your country selection in step
2, the answering system announcement
language changes as follows (KX-TG7861
series: page 3):
– “Other” = English
– “Česká rep.” = Czech
– “Slovensko” = Slovak
R After changing the unit’s region setting/
resetting the base unit,
may be
displayed on the handset momentarily. This
is normal and the handset can be used
once
is displayed.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 5. If another handset model is
used, certain operations may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1 Handset:
M
N (right soft key) #130
2 Base unit:
Proceed with the operation for your model.
n KX-TG7851 series: page 3
Press and hold M
N for about 5
seconds. (No registration tone)
n KX-TG7861 series: page 3
Press and hold M
N for about 5
seconds, until the registration tone
sounds.
R If all registered handsets start ringing,
press M
N again to stop, then repeat
this step.
R The next step must be completed
within 90 seconds.
3 Handset:
MOKN a Wait until “Base PIN” is
displayed. a Enter the base unit PIN
(default: “0000”). a MOKN
R If you forget your PIN, contact an
authorised service centre.
R When the handset has been registered
successfully, is displayed.
Note:
R While registering, “Base in
registering” is displayed on all
registered handsets.
R When you purchase an additional handset,
refer to the additional handset’s installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
32
Programming
TG7851_61FX(en)_0215_ver011.pdf 32 2013/02/15 18:28:13