Filter
Top Products
Programming
29
the phone number matches an entry in
the call barred list, the unit sends out a
busy tone to the caller, and then
disconnects the call.
Important:
L When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 33) with 7 after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.
Important:
L You must store the phone number
with an area code in the call barred
list.
■ From the caller list:
1 {<} (y)
2 {V}/{^}: Select the entry to be
barred. i M i I
3 {V}/{^}: “Caller Barred” i
M
4 {V}/{^}: “Yes” i M i
{ic}
■ By entering phone numbers:
1 1 i {#}{2}{1}{7} i m
2 Enter the phone number (24
digits max.). i M
L To erase a digit, press ^.
3 {ic}
Viewing/editing/erasing bar call
numbers
1 1 i {#}{2}{1}{7}
2 {V}/{^}: Select the desired entry.
L To exit, press {ic}.
3 To edit a number:
~ i Edit the phone number.
i M i {ic}
To erase a number:
W i {V}/{^}: “Yes” i M
i {ic}
Note:
L When editing, press the desired dial
key to add, ^ to erase.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, contact an authorised
service centre.
1 1 i {#}{1}{3}{2}
2 Enter the current 4-digit base unit
PIN (default: “0000”).
3 Enter the new 4-digit base unit PIN.
i M i {ic}
Registering a unit
Operating additional units
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when “Auto” is selected on
base unit (page 30), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a “radio
cell”.
TG7511_7521BX(e).book Page 29 Tuesday, June 15, 2010 2:10 PM