Filter
Top Products
Error messages
Display message Cause/solution
Base no power
or
No link. Reconnect
AC adaptor.
or
No link.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been cancelled.
Re-register the handset (page 47).
R When “No link.” is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Check Phone Line
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 8).
Error
R Recording was too short. Try again.
Memory Full
R The phonebook memory is full. Erase unwanted entries
(page 19).
R Message memory is full. Erase unwanted messages
(page 33, 34).
R The call barred list memory is full. Erase unwanted entries
(page 28).
Use rechargeable
battery.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
You must first
subscribe to Caller
ID.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
43
Useful Information
TG68xxSA(en)_0619_ver011.pdf 43 2013/06/19 17:43:18