Filter
Top Products
Programming
31
Programming using the direct commands
1 {MENU}
2 Enter the desired feature code.
3 Enter the desired setting code.
L This step may vary depending on the
feature being programmed.
4 {Save} i {OFF}
Note:
L In the following table:
– < > shows the default setting.
– If “System setting” column is checked,
you do not need to programme the
same item using another handset (KX-
TG5922).
L If you make a mistake or enter the wrong
code, press {OFF}, then start again by
pressing {MENU}.
Feature Feature
code
Setting code System
setting
Auto talk
*1
{0}{3}{1}: On {0}: <Off>–
Copy phonebook (1 item)
*2
{#}{1} (page 24) –
Copy phonebook (all items)
*2
{#}{2} (page 24) –
Key tone
*3
{0}{2}{1}: <On> {0}: Off –
LCD contrast
(Display contrast)
{0}{1}{1}–{6}: Level 1–6 <3> –
Message alert {0}{#} {1}: On {0}: <Off>–
Registration {0}{0} (page 36) –
Ring colour
(Ringer indicator colour)
{1}{4}{1}: <Colour1>=Amber
{2}: Colour2=Green
{3}: Colour3=Red
{4}: Multicolour
–
Ringer tone {1}{2}{1}–{3}: Tone <1>–3
{4}–{7}: Melody 1–4
–
Ringer volume {1}{1}{1}: Low {2}: Medium
{3}: <High> {0}: Off
–
Set area code {0}{4} (page 27) –
Set dial mode {0}{5}{1} (page 45) r
Set line mode
*4
{0}{5}{3}{1}: A {2}: <B> r
TG5921AL_5922AL.book Page 31 Friday, February 24, 2006 3:42 PM