Filter
Top Products
Answering System
Preparation
73
Telephone System Useful Information
If the Following Appears on Your Display...
Troubleshooting
If the handset display shows error messages, see “If the Following Appears
on Your Display...” (p. 71–73) for the Cause & Remedy.
Display message Cause & Remedy
Wrong handset
Refer to manual
• This handset is not for this base unit. This handset is
for KX-TG6500C base unit, not the KX-TG5230C
base unit included with this system. The accessory
handsets for this base unit are KX-TGA520C and
KX-TGA523C.
Problem Cause & Remedy
“No link to base.
Move closer to
base and try
again.” is displayed and an
alarm tone sounds.
• The handset has lost communication with the
base unit. Walk closer to the base unit, and
try again.
• Confirm that the base unit’s AC adaptor is
plugged in.
• Raise the base unit antennas.
• The handset’s registration may have been
cancelled. Re-register the handset
(p. 69, 70).
The handset and/or base unit
does not work.
• Check the settings (p. 11–13).
• Check whether the dialing mode setting is
correct (p. 17).
• Fully charge the battery (p. 12).
• Clean the charge contacts and charge again
(p. 13).
• Check battery installation (p. 12).
• Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• The handset has not been registered to the
base unit. Register the handset (p. 70, steps
5 and 6).
•
Re-install the battery (p. 12) and fully charge it.
TG5230C_English.fm Page 73 Tuesday, May 11, 2004 9:08 AM