Filter
Top Products
Useful InformationAnswering System
Preparation
69
Troubleshooting
Telephone System
You cannot program any
function items.
• Programming is not possible while the handset
and/or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• When the dial lock is turned on, you cannot
store phone numbers (p. 34, 41). To turn the
mode off, see page 56.
While programming or
searching, the handset or base
unit starts to ring and the
program/search stops.
• A call is coming in. To answer the call, press
[
C], [s] or [SP-PHONE]. Start again from the
beginning after hanging up.
You cannot make an intercom/
outside call.
• If more than one other user is using the
handset and/or base unit, you may not be able
to make a call. Try again later.
• The handset you called is too far from the base
unit.
• You cannot make an outside call when the dial
lock is turned on. To turn the mode off, see
page 56.
• Set the dialling mode to “Tone” (p. 21).
You cannot redial. • If the last number dialled was more than 48
digits long, the number will not be redialled
correctly.
• The [REDIAL/PAUSE] button on the base unit
functions as either redial or pause. It will redial
the last number dialled if pressed before
dialling any digits (p. 25). If another number
has been dialled first, it will operate as a pause
button (p. 51).
• You cannot redial when the dial lock is turned
on. To turn the mode off, see page 56.
Problem Cause & Remedy
TG5230AL.fm Page 69 Friday, June 11, 2004 5:31 PM