Filter
Top Products
Troubleshooting
56
“” is displayed and the
ANSWER ON indicator
flashes rapidly. No new
messages are recorded.
• Memory is full. Erase unnecessary
messages (p. 46).
You cannot operate the
Answering System with the
base unit.
• The handset user is operating the Answering
System, or is on the phone. Wait until the
IN USE/CHARGE indicator light goes out.
You cannot operate the
Answering System from a
touch tone phone.
• Make sure you enter the correct remote code
(p. 48).
• The Answering System may not respond if
the tones are too short to activate the unit.
Press each button firmly.
• The Answering System is off. Turn it on
(p. 50).
You cannot operate the
Answering System with the
handset.
• Someone is operating the Answering
System.
• You are too far from the base unit. Walk
closer to the base unit.
• The unit is recording a message. To answer
the call, press
[]
or
[]
.
While recording a greeting
message, the unit starts to
ring and stops recording.
• To answer the call, press
[SP-PHONE]
,
[]
or
[]
. Start again from the beginning after
hanging up.
During playback, the unit
starts to ring and stops
playback.
• To answer the call, press
[SP-PHONE]
,
[]
or
[]
. To resume playback, press
[MESSAGE/SLOW TALK]
after hanging up.
Caller ID information is not
displayed during message
playback (p. 45).
• Caller ID information will not be displayed
— if a message is recorded by using
[MEMO/2WAY REC]
(p. 47), or
— if the Caller List is renewed and the caller
ID information is erased (p. 28).
Problem Cause & Remedy
FULL