Filter
Top Products
Making Calls
Cordless Telephone
For assistance, please call: 1-800-211-PANA(7262)
25
Using the Base Unit
To adjust the speaker
volume (8 levels) while
talking
To increase volume, press
VOLUME [ ]
.
To decrease volume, press
VOLUME [ ]
.
• If you try to increase/decrease
volume when it is at the maximum/
minimum level, the base unit will beep
3 times.
To redial the last number
dialed on the base unit
Press
[SP-PHONE]
then
[REDIAL]
.
To put a call on hold
Press
[HOLD]
.
• The SP-PHONE indicator flashes.
To return to the call,
press
[SP-PHONE]
.
• The handset user can return to the
call by pressing
[]
or
[]
, or lifting
the handset off the base unit.
• If another phone is connected on the
same line, you can also return to the
call by lifting its handset.
• If a call is kept holding for 6 minutes,
an alarm tone will start to sound. After
4 additional minutes on hold, the call
will be disconnected.
• The alarm volume corresponds to the
ringer volume level (p. 17). If the
ringer is OFF, the alarm will sound at
the LOW level.
1
Press
[SP-PHONE]
.
• The SP-PHONE indicator lights.
2
Dial a phone number.
3
When the other party answers, talk
into the
MIC
(microphone).
4
To hang up, press
[SP-PHONE]
.
• The indicator light goes out.
• To switch to the handset while using the base unit speakerphone:
— If the handset is off the base unit, press
[]
or
[]
.
— If on the base unit, just lift up.
• During a call using the handset, the call can be switched to the base unit by
pressing
[SP-PHONE]
on the base unit.
Base Unit
[SP-PHONE]
and Indicator
[REDIAL]
VOLUME [], []
>
>
MIC
[HOLD]
Hands-free Digital Duplex Speakerphone
For best performance, please note the following:
• Talk alternately with the other party in a quiet room.
• If you or the other party has hearing difficulty, press
VOLUME
[]
to decrease
the speaker volume.
>
>
>