Filter
Top Products
97
Chapter 5
Useful Information
With the cordless handset
Problem
The unit does not work.
“No link to base.
Walk closer to
base & try again” is
displayed and an alarm
tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The unit does not ring.
You cannot dial.
The display is blank.
You cannot program
function items, such as the
line selection.
Remedy
•Charge the battery fully (p. 16).
•Clean the charge contacts and charge
again (p. 17).
•Install the battery properly (p. 90).
•Re-install the battery and place the handset
on the charger (p. 90). Try again.
•The handset has not been registered to the
base unit. Register the handset (p. 19, 53).
•You are too far from the base unit.
Walk closer to the base unit and try again.
•Raise the base unit antenna.
•Locate the cordless handset and the base
unit away from other electrical appliances
(p. 4).
•Walk closer to the base unit.
•Raise the base unit antenna.
•The ringer volume is set to OFF. Select
HIGH or LOW (p. 22).
•If 2 other handsets or the base unit and
another handset are in use, the unit may
not ring. The handset and base unit users
will hear incoming call tones.
•
The handset is removed from the ring group.
Add to the ring group (p. 23).
•The dialed number is restricted. To cancel,
see page 51.
•Key lock mode is set. Cancel the mode by
pressing and holding (FUNCTION).
•Charge the battery fully (p. 16).
•Programming is not possible while in the
talk or intercom mode, or while listening to
messages.
•Do not pause for over 60 seconds while
programming.
•Make sure that the handset is in the
standby mode.