Filter
Top Products
2.10 Starting the Advanced Hybrid System
76 Installation Manual
To clear outgoing messages (OGMs) for DISA/UCD:
[when using the 2-Channel Voice Message Card for the first time]
To initialise the 2-Channel Voice Message Card:
8. Press the PROGRAM button to exit system programming mode.
9. Programme the PBX using either one of the following methods:
CAUTION
• The PBX is powered as long as the AC cord is plugged into an AC outlet, even if the Power
Switch is set to the "OFF" position.
• The power supply cord is used as the main disconnect device. Ensure that the AC outlet is
located/installed near the equipment and is easily accessible.
Notes
• If the outside (CO) lines you use are not connected to the PBX, outside (CO) line type cannot
be automatically detected.
• Use only the AC cord included with the PBX.
• If the PBX will not be used for an extended period of time, set the Power Switch to the "OFF"
position and disconnect the AC cord from the AC outlet to conserve power.
Notes
• The type of outside (CO) line is automatically detected.
• If the PBX does not function properly, refer to "4.1.5 System Reset with System Data
Clear".
e. Enter 599.
f. Press the NEXT (SP-PHONE) button.
g. Press the STORE (AUTO DIAL/STORE) button.
h. Press the END (HOLD) button.
a. Enter 808.
b. Press the NEXT (SP-PHONE) button.
c. Press the STORE (AUTO DIAL/STORE) button.
d. Press the END (HOLD) button.
CAUTION
The 2-Channel Voice Message Card must be inserted before start up.
a. PC programming. Refer to "Section 3, Guide for KX-TE Maintenance Console".
b. PT programming. Refer to "3.3 PT Programming" of the Feature Guide. Users in countries
such as Italy and the Czech Republic are required to set the country code prior to all other
settings.