Filter
Top Products
2.3 Installing Optional Service Cards
52 Installation Manual
2.3.5 3-Port Caller ID Card (KX-TE82493)
Function
Adds Caller ID support for 3 outside (CO) lines. 1 card can be installed for outside (CO) lines 1–3. A
second card can be installed for outside (CO) lines 4–6, and a third card can be installed for outside
(CO) lines 7 and 8.
FSK (Frequency Shift Keying) and DTMF (Dual Tone Multi-Frequency) Caller ID types are supported.
For information on the type of Caller ID used in your area, contact your telephone company.
1. Loosen the screws and open the top and bottom front covers. (→ 2.2.3 Opening/Closing Covers)
2. Slide the card between the guiderails until it clicks, and attach the connector to it.
Note
Use extra care to make sure you do not damage the part of the case marked with a circle.
3. Close the covers and secure the screws. (→ 2.2.3 Opening/Closing Covers)
Note
To uninstall the card, follow the instructions illustrated below.
1. Push the catch on the side of one guiderail in the direction of the arrow to release it.
2. Lift the edge of the card while holding the catch open. (Do not touch the circuit board of the card
during the operation.)
KX-TE82493
for outside (CO)
lines 1–3
For outside (CO)
lines 7 and 8
For outside (CO)
lines 4–6
Guiderail
1
2