Filter
Top Products
Setting the Remote Code
The remote code prevents unauthorized people from accessing your unit
and listening to your messages Choose any
24git
number (00-99)
The factory preset remote code is “11” If you do not program your own
remote code, you can use “11”
Use the handset near the base unit. Make sure the unit is in the
standby mode initially
1
2
3
4
5
6
7
Press
(FUNCTI~NIEXITICH]
Press
@
or
@
repeatedly until the arrow
points to
"Program"
Press
FWD/EDIT
@I
(Yes key)
Press
@I
or
@J
repeatedly until the arrow
points
to
"TAD program"
Press
FWD/EDIT
@
(Yes key)
*The base unit display shows programming
options
Press
@I
*The current remote code is displayed on the
base unit
Enter a remote code using a
2-digit
number (00-99)
Press
FWD/EDIT
@
(Save
key)
*A
beep sounds
FProgram
b=Yes
FSave
DIRECT#
Set flash
time
TA
b=Yes
Base unit display
Remote code
_
_
L-----2
*To
return to the standby mode, press
FUNcTION/EXIT/CH
elf 6 beeps sotind during programming, a wrong key was pressed Enter the
correct number
To
check the remote code
Repeat steps 1 to
6
*The current remote code is dispiayed on the base unit When finished, press
[FUNCTI~NIEXIT/CH)
61