Filter
Top Products
52
Setup
(KX-FP185/KX-FM189 only)
TAD/FAX mode!
(using the built-in answering device and receiving
voice and fax calls automatically)
Setting up the voice and fax message reception
When the TAD/FAX mode is set, the unit will work as a fax machine and/or answering device.
If a fax call is detected, the unit will automatically receive the fax. If a voice call is detected, the
answering device will play a greeting message and the caller can leave a voice message.
●
You can use either the pre-recorded greeting messages (see next page) or your own greeting
message (p. 54).
Note:
●
The incoming message recording time can be
changed (feature #10 on page 65).
●
For voice memory capacity for incoming messages,
see page 86.
●
When the remaining time is low, erase unnecessary
messages (p. 57).
●
While an incoming call is being recorded, you can
monitor it through the speaker. If this feature is not
required, set to “OFF” (feature #67 on page 70).
AUTO ANSWER
Display
1
Set feature #77 to “TAD/FAX” (p. 71).
2
If the arrow (▼) is not shown on the right of
the display, turn it on by pressing
.
Display:
●
The unit will play the greeting message.
●
The remaining time for recording incoming
messages will be displayed.
Example:
ON
▼
TIME = 10m13s
TAD/FAX MODE
AUTO ANSWER
Ring count in the TAD/FAX mode
The number of rings before a call is answered can be changed on feature #06 (p. 65).
You can choose from 1, 2, 3, 4, TOLL SAVER and RINGER OFF.
TOLL SAVER: When you call the unit from a remote location, the number of rings will tell you if there are
any new voice messages. If the unit answers on the second ring, there is at least one
new recorded message. If the unit answers on the fourth ring, there are no new recorded
messages. To save the toll charges for the call, hang up immediately when you hear the
third ring. The third ring indicates that there are no new recorded messages.
RINGER OFF: The unit will answer without ringing.
●
If you subscribe to a Caller ID service, set to 2 or more rings.