Filter
Top Products
14 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Useful Information
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Problem Cause & solution
w is flashing. LThe handset is too far from the base unit. Move
closer.
LThe AC adaptor is not connected. Check the
connections.
LYou are using the handset or base unit in an area
with high electrical interference. Locate the
handset and base unit away from interference
sources, such as antenna and mobile phones.
LThe handset registration is cancelled. Register the
handset to the base unit using the following
method.
1 {j/OK}
2 “SETTING HS” i {>}
3 “REGISTRATION” i {>}
4 “REGISTER HS” i {>}
5 Press and hold {x} on the base unit until the
registration tone sounds.
LThe rest of the procedure must be completed
within 1 minute.
6 Select a base unit number ({v}). i {>}
7 Wait until “BS PIN” is displayed. i Enter
base unit PIN (default: “0000”). i {>}
LA confirmation tone will sound, and w will
stop flashing.
I cannot make or receive calls. L The AC adaptor or telephone line cord is not
connected. Check the connections.
LThe call bar feature is turned on. Turn it off (page
10).
LYou dialled a call restricted number (page 12).
LThe key lock feature is turned on. Turn it off (page
8).
The unit does not ring. LThe ringer volume is turned off. Adjust the ringer
volume (page 10, 11).
The handset display is blank. LThe handset is not turned on. Turn the power on
(page 5).
TCD150E(E).book Page 14 Wednesday, May 25, 2005 4:58 PM