Filter
Top Products
- Setting up -
9
3.9 Modem Connection
The telephone has a “MODEM” socket for connection of a modem or fax
machine on the right side of the unit. Please note that this connection uses the
same telephone line as the telephone itself. The connected device cannot be
used at the same time as the telephone.
3.10 Recall setup
You can use the Recall button on your telephone when using your network
operator’s services such as call waiting etc. A subscription may apply for these
services, contact your network operator more information. If this is not working
correctly check the setting of the Recall timing inside the Settings Menu. Refer
to chapter 6 for viewing and changing the Recall setting. In Australia it should
be set at 100ms and for New Zealand it should be set at 600ms for use on a
normal telephone line.
3.11 Setting the Time / Date
If you want to res
et the current time and date or change a value already entered,
proceed as follows:
Note: All entries must be made as two digits. If you want to enter the date 8
th
of
October, press the numbers 08 for the day and 10 for the month.
PLEASE FOLLOW THE INSTRUCTIONS: Display shows:
Press the MENU button.
Add entry
Turn the Jog dial until the “Settings” message appears in
the display.
Settings
Now press the YES button twice.
Date and time. The first
figure of the date
flashes.
Now enter the current day, the month, the hour and the
minutes one after the other using the keypad.
If you want to set the
24
th
October and the
time 15.05, enter the
numbers “24 10 15 05”
using the keypad.
The date and time are saved by pressing the YES
button.
To exit programming mode, press the NO button twice.