Filter
Top Products
14
7.2 To review the Phone Book Memory
1. Press and release
CID
button until the phone symbol is shown.
2. Review the stored phone number by pressing or , or enter the first
letter of the name of the person you wish to call. After a short time, the
display will display the first stored telephone number and say the name if
it was recorded. You can now search for further numbers under this letter
by pressing .
Notes:
• If no telephone numbers are stored, the display will show EMPTY.
• After you view all the call in memory, the display will show END OF LIST.
7.3 To dial a number from the Phone Book:
1. With the required telephone number showing on the display, press CALL
BACK button. The telephone dials out the displayed telephone number
automatically in speakerphone mode.
2. The display shows the telephone number and call timer.
OR
1. Pick up the handset or press SPEAKER button (the speaker light will turn
on) and wait for a dial tone.
2. Press and release
CID
button, symbol is shown.
3. Review the stored phone number by pressing or .
4. Press CALL BACK button.
7.4 Recording / Editing / Deleting voice prompt of name of phone
book
With caller ID service activated, when an incoming call is received, the unit
will display and announce the caller's phone number (unless it is blocked). If
the caller's phone number is stored in the phone book, caller's name will be
displayed too.
If the voice prompt is recorded for this phone number, the unit will announce
the voice prompt instead of the caller's phone number.
1. Press and release the MENU button until the NAME RECORDING is
shown.
2. Press the OK button. A list of the phone book entries will be displayed.
3. Press or to select the list you like to record a voice or name for it.
4. To record or edit the voice, hold down OK button. After the beep, speak
clearly into the microphone. Release the button when you are finished
(max recording time is 3 seconds.) The new voice prompt will then be
replayed automatically.
To delete the voice prompt recorded, press DELETE button while the
voice prompt is playing.
5. Repeat steps 3 to 4 to edit or delete entries or exit the set-up mode by
pressing the
CID
button.