Filter
Top Products
Installing your IP Phone 1220
34
1. Plug the headset cord into the headset jack on the back of the IP
Phone marked with the
) symbol.
Figure 4 on page 32 shows the connections on the back of the
IP Phone 1220.
2. Thread the cord through the channel in the side of the foot stand.
3. Set up the headset according to the headset instructions.
Connecting the power (optional)
Your IP Phone 1220 supports AC power and Power over Ethernet (PoE).
For AC power, use only the Nortel-approved Global Power Supply
(N0146475) and the country-specific IEC cable that you can order
separately. To use PoE, your connected LAN must support PoE.
Note: Your IP Phone 1220 supports AC power and PoE options,
including IEEE 802.3 standard power. To use local AC power, you can
order separately the optional AC adapter. To use PoE, where power is
delivered over the CAT5 cable, the LAN must support PoE, and you
do not need an AC adapter.
1. Connect the DC barrel connector to the power jack on the back of the
IP Phone.
2. Thread the cable through the channel in the foot stand to secure the
cable.
3. Plug the country-specific IEC cable into the Global Power Supply,
and then plug the Global Power Supply into the nearest AC power
outlet.
Figure 4 on page 32 shows the connections on the back of the
IP Phone 1220.
CAUTION
Use your IP Phone 1220 with the
approved Nortel AC Adapter (model
#N0089601).