Filter
Top Products
Page 58 of 62 Handset configuration
553-3001-229 Standard 1.00 November 2005
Procedure 13
Configuring the WLAN Handset 2212 using the cradle
1 Before you begin, do the following:
a. Remove the battery before placing the handset in the cradle
b. Connect the serial cable to the COM port.
c. Load the latest software (0.60 or later) on the telephone. The
configuration cradle only works with Phase II software (0.60 or later).
2 Decompress the configuration cradle file (version 2.11.02) to a folder on
the hard drive.
3 Double-click on PhoneConfig.exe in the folder.
The Config Cradle window appears, as shown in Figure 33. The settings
for the telephone are grouped into three main categories: System, Group,
and User. User is the default group for the settings at startup and this
should be sufficient for a few phones. For larger deployments, planning
will be required for the settings.
Figure 33
Config Cradle window
4 Place the handset in the cradle.
5 Click Read Phone on the configuration tool.
The tool is populated with the VPN settings as shown in Figure 34 on
page 59.