Filter
Top Products
Page 33 of 62
WLAN Handset 2212 Installation and Configuration for VPN
36
IP address pool configuration
Contents
This section contains information on the following topics:
Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
IP address pools. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
Proxy ARP and tunnel-to-tunnel traffic . . . . . . . . . . . . . . . . . . . . . . . . 35
Introduction
This section describes how to configure an IP address pool and enable proxy
ARP and tunnel-to-tunnel traffic.
IP address pools
Use Procedure 5 to configure an IP address pool.
Procedure 5
Configuring an IP address pool
1 In the Contivity Secure IP Services Gateway window, select SERVERS >
User IPaddr.
The User IPaddr window appears, as shown in Figure 11 on
page 34.