NEC AT-35 Telephone User Manual


 
INSTALLATION
IMPORTANT:
Disconnect telephone line cord before removing battery cover to
replace the batteries. Battery cover must be in place at all other times.
Replace all batteries every six (6) months.
When the low battery indicator appears on the LCD, replace all
batteries immediately.
To retain information stored in memory, replace batteries within one (1)
minute.
Use only new batteries of the specified size and type.
Never mix new and old batteries.
Use of alkaline batteries is recommended.
Do not use nickel-cadmium batteries.
Battery Safety Precautions:
For your safety, please observe these precautions:
Do not recharge, disassemble, mutilate, wet or incinerate batteries.
Keep batteries out of reach of children.
Use batteries of the same type; do not mix different type of batteries.
Remove dead batteries from the telephone set immediately.
Connecting the Telephone
1. Connect one end of the handset cord with the short cord to the handset
jack, connect the other end with the long cord to the HANDSET socket
on the rear of the telephone.
2. Fit one end of the line cord to the LINE socket on the rear of telephone
and the other end to your telephone network outlet.
3. Lay the handset cord in the groove on the bottom of the telephone.
For best speakerphone performance, avoid the following:
Areas with high background noise. (The microphone might pick up
these sounds and prevent the speakerphone from going into receiving
mode when you finish talking.)
Surfaces affected by vibration.
Recessed areas such as in a corner, inside a cupboard, or next to a
cabinet, which can generate an echo effect.
6