NEC AT-35 Telephone User Manual


 
INITIAL SETUP
Setting the Flash Time
The correct hookflash timing depends on the requirements of the PBX to
which the telephone is connected.
1. Ensure the phone is idle.
2. Dial ¿ 4 1 ¿.
3. Dial 00 to 06 to select from the following list of hookflash timings.
00: 95ms
01: 100ms (Default)
02: 120ms
03: 180ms
04: 270ms
05: 300ms
06: 600ms
4. Dial #.
Setting the PBX DIAL Code
When installed as a PBX extension, a trunk access code is often required
to precede external numbers that are dialled. The PBX DIAL key can
automatically insert the PBX trunk access code at the front of a dialled
number, when dialling from a One-Touch key, the IN List (Caller ID), or
when Preview Dialling.
The PBX trunk access code may differ from site to site, according to how
the PBX is configured. To set the PBX DIAL code, follow the steps below.
To change the PBX DIAL code:
1. Ensure the phone is idle.
2. Dial ¿ 0 ¿.
3. Dial the PBX trunk access code 0 to 9. (Default=not assigned.)
4. Dial #.
To clear the PBX DIAL code:
1. Ensure the phone is idle.
2. Dial ¿ 0 ¿ #.
9